Ordering Information
 
 
AVP sells through world-wide distribution

USA  

Canada

Europe

Latin America

China/HK/Taiwan

 Other International

 

 
For the dealer nearest you, call:

USA and Canada:

  1-800-481-2493

Outside North America:

  1-519-740-7966

fax:

  1-519-740-0131

email:

  sales@jackfields.com
 
Delivery
Many products are stock. Lead times are generally 1 to 2 weeks on all catalog items. Very large quantities require longer, 2 to 4 weeks. Custom orders are 3 to 6 weeks.
 
 
Options Summary
 
110 Ohm Digital Wiring
All AVP wired audio jackfields feature 110 Ohm AES/EBU wiring.
Note: AES jackfields are also suitable for analog application.
 
Bussed Grounds
Most wired jackfields are supplied with Ground Posts on the rear interface panel.
These are not wired unless the bussed ground option is added to your order.
To order the bussed ground at jacks option, add -BGHJ to the model number.
To order the bussed ground at rear option(available on punch products only), 
add -BGHR to the model number.
When there is just one ground post on the rear panel, all jack grounds are common.
When there are two ground posts, the top and bottom jack rows are bussed individually.
These can easily be externally commoned by the installer if required.
 
Umbilical Length
The umbilical cable length is the distance from where the cable bundle leaves the jackpanel to where it enters the rear panel. This does not apply to jackfields with a full enclosure.
Standard Length is 40", 102cm. To order a custom length add -Uxxx. You must replace xxx with the total umbilical length required in inches, including the original 40", 102cm.
 
Designation Strip Locations
All Mosaic Models are Top and Bottom Designations. For many Standard Product Line models, the designation locations can be changed. To order these changes:
  1. If the standard product-line catalog item has a front panel with top and bottom designations, add -TM to the model number for top and middle designations.

 
  1. If the standard product-line catalog item has a front panel with top and middle designations, add -TB to the model number for top and bottom designations.
Normals Installed at the Rear (Normals out units only)

To save onsite installation time, AVP can install the external jumpers for full or half normals.
For full normals factory installed add -FR to the model number.
For half normals factory installed add -HR to the model number.
 
In the interest of improved design and performance, AVP reserves the right to make changes in its specifications without prior notice.